HOT ROD SLED SHOP PDM3 CLUTCH RAMPS- NEW FOR 2024

NEW FOR 2024 HRSS PDM3 CLUTCH RAMP SET: 84 GRAM BASE WEIGHT: Hot Rod Sled Shop Ski-doo PDrive Adjustable PDM3 CLUTCH RAMPS were specifically designed for higher horsepower 850, 850 turbo and 900 turbo aplications. These have the same profile as the PDM2 weight but are a heavier base weight with a large amount of the weight concentrated toward the base keeping great backshift and throttle response. Our weights are machined from 4130 chromoly heat treated steel. We then use Igus I-glide German made bushings for almost zero bushing failures and a 25% closer tolerance on the axle for more precise weight travel as it goes through its cycles than the oem Ski-doo "shaker" style weights as we call them. Our weight eliminates the stock clicker system which we believe is a great benefit in even more precise tuning in exact shift locations than the Ski-doo OEM ramps. Our shift curve is different than any stock ramp. It loads the motor harder and then aggressively upshifts for quicker acceleration while maintaining good top mph with a lower full shift profile. Our ramps squeeze the belt harder, sooner and softer at engagement than the twitchy stock ramps. Comes with 62 magnets … enough to fill the weights plus 2 extra. ALL OF OUR HRSS PDM SERIES WEIGHTS FEATURE:

*4130 CHROMOLY STEEL CONSTRUCTION * HEAT TREATED AND HARDENED * SAME CUSTOM HRSS SHIFT CURVE * 1.1 GRAM EPOXY COATED MAGNETS * IGUS I-GLIDE BUSHINGS * BLACK OXIDE COATED SURFACES